Optimization of Nitrogen Fertilizer and Water Consumption in Sugar Beet by using Response-Surface Method

Document Type : Scientific - Research

Authors

• Hamed Mansouri ¹
• Hamid Noshad ²
• Mahdi Hassani ¹

¹ Sugar Beet Research Department, Hamedan Agricultural and Natural Resources Research and Education Center, Education and Promotion Organization (AREEO), Hamedan, Iran

² Sugar Beet Seed Institute, Agricultural Research, Education and Promotion Organization (AREEO), Karaj, Iran

10.22067/jag.v13i1.79767

Abstract

Introduction
With respect to this issue that Iran is located in semi-arid conditions and limited by water resources, so water conservation in agricultural systems plays main role to increase production and determination of water optimum amount is first step to gain this purpose. Nitrogen is one of the main effective factors on quantity and quality of crops. According to the studies, only 40-60% of nitrogen fertilizers is used by crops and this value decreases with increasing of fertilizer application. There is complicated interaction between amount of irrigation water and nitrogen fertilizer, thus it is necessary to consider optimum level of them simultaneously. To obtain acceptable economical yield and reducing environmental pollutions, used inputs in farms should be applied as optimum with respect to expected target. One of the important methods to gain optimum level of inputs is response-surface method. There is no study to investigate usage of this method for inputs optimization in sugar beet. Therefore, the purpose of the study was optimizing of nitrogen fertilizer and irrigation in sugar beet via the response-surface method by using a central composite design.
Material and Methods
We used available data and information from studies which had been accomplished about nitrogen fertilizer and irrigation in Hamedan, Iran to determine optimum levels of these treatments. So needed treatments were designed based on high and low levels of nitrogen fertilizer (0 and 240 Kg.ha^-1) and irrigation (8000 and 14000 m³.ha^-1) by Minitab software ver.16 as central composite design (CCD). CCD is one of the response-surface methods and the number of treatments in this design is calculated by equation of 2^k + 2k + r, where k is the studied factors and r is number of replication for central point. Number of replication for central point under two factors has been reported as 5, thus for central composite design with two factors, 13 treatments is needed. To fit data, regression equation was used and evaluated based on regression variance analysis. In general, the full quadratic polynomial equation was tested to determine the significance of the model and the components of the model. RMSE, ME, R² indexes and 1:1 line were used to judge the difference between simulated and observed data.
Results and Discussion
ANOVA results showed that regression model was significant to estimate all dependent variables based on F test. Correlation coefficient of dependent variables including root yield, sugar and sugar white, water use efficiency and nitrogen use efficiency determined as higher than 96%. It implies that the high proportion of the variability for these traits was explained by the fitted regression model. According to the lower values of RMSE than 10 and higher values of ME than 0.89, it could be concluded that the model had acceptable and suitable results to estimate studied traits in sugar beet. The results of t-test to compare fitted regression with line 1:1 illustrated that slope and intercept values in fitted and 1:1 line had no significant difference. The results showed that root, sugar and white sugar yield were increased by increasing nitrogen fertilizer under all levels of irrigation. Response-surface curve of α-amino nitrogen as affected by irrigation and nitrogen fertilizer indicated that α-amino was elevated by increasing nitrogen fertilizer application. As data, water use efficiency decreased by water consumption. In the other hand, nitrogen use efficiency was decreased by applying nitrogen fertilizer under all levels of irrigation. Optimum range of treatments were obtained as 9500-12000 m³.ha^-1 for irrigation and 110-130 Kg.ha^-1 for nitrogen fertilizer treatment based on overlaid plot method. The results of treatments optimization by using analytical solution method illustrated that applying 133 Kg.ha^-1 and 10667 m³.ha^-1 were suggested as optimum amounts of treatments. Based on these optimum levels of treatments, root yield, sugar and white sugar yield, α-amino, water use efficiency and nitrogen use efficiency were estimated as 80.1 ton.ha^-1, 14.94 ton.ha^-1, 12.49 ton.ha^-1, 2.56 meq.100 g^-1, 1.39 Kg sugar.m^-3 and 74.24 Kg sugar. Kg^-1, respectively.
Conclusion
As result, to optimize treatments including nitrogen fertilizer and irrigation, response-surface method had acceptable adequate to predict variables in sugar beet based on statistical indexes. Optimum value of nitrogen fertilizer and irrigation were predicted as 133 Kg.ha^-1 and 10667 m³.ha^-1, respectively by using analytical solution. Therefore, the results indicate that the application of optimum values can reduce environmental hazards and produced acceptable sugar yield.

Keywords

• Central Composite Design
• Optimum Treatment
• Sugar Yield
• Water Use Efficiency
• Nitrogen Use Efficiency

20.1001.1.20087713.1400.13.1.4.3

---

References

Aslan, N., 2007. Application of response surface methodology and central composite rotatable design for modeling the influence of some operating variables of a Multi-gravity Separator for coal cleaning. Fuel 86: 769–776.

Bannayan, M., Mansoori, H., and Eyshi Rezaei, E., 2014. Estimating climate change, CO₂ and technology development effects on wheat yield in northeast Iran. International Journal of Biometeorology 58: 395-405.

Box, G.E.P., and Hunter, J.S., 1957. Multi-factor experimental design for exploring response surfaces. Annals of Mathematical Statistics 28:195–241.

Box, G.E.P., and Wilson, K.B., 1951. On the experimental attainment of optimum conditions. Journal of the Royal Statistical Society: Series B (Statistical Methodology) 13: 1–45.

Hills, F.J., Winter, S.R., and Henderson, D.W., 1990. Sugar beet. In: Stewart, B.A., Nielsen, D.R., (Eds.). Irrigation of Agricultural Crops. pp. 795-810, Madison, Wisconsin, USA.

Hossain, M., and Mohona, M.J., 2018. Shoot-root traits of broccoli (Brassica oleracea var. italica L.) as influenced by different irrigation schedules. International Journal of Horticultural Science and Technology 5(1): 11-18.

Hosseinpour, M., 2008. Water and radiation use efficiency of winter sugar beet affected by nitrogen, irrigation and growth duration management. Final Report of Sugar Beet Seed Institute. Karaj, Iran. (In Persian with English Summary)

Jahan, M., Nassiri Mahallati, M., Khalilzade, H., Bigonah, R., and Razavi, A.R., 2016. Optimizing of nitrogen, phosphorus and cattle manure fertilizers application in winter wheat production using response-surface methodology (RSM). Iranian Journal of Field Crops Research 13(4): 823-839. (In Persian with English Summary)

Jahedi, A., Nourozi, A., Hassani, M., and Hamdi, F., 2012. Effect of irrigation methods and nitrogen application on sugar beet yield and quality. Sugar Beet 28(1): 43-53. (In Persian with English Summary)

Kalavathy, H.M., Regupathib, I., Pillai, M.G., and Miranda, L.R., 2009. Modelling, analysis and optimization of adsorption parameters for H₃PO₄ activated rubber wood sawdust using response surface methodology (RSM). Colloids and Surfaces B: Biointerfaces 70: 35–45.

Koocheki, A., Nassiri, M., Moradi, R., and Mansouri, H., 2014. Optimizing water, nitrogen and crop density in canola cultivation using response surface methodology and central composite design. Soil Science and Plant Nutrition 1: 1-13.

Kwak, J.S., 2005. Application of Taguchi and response surface methodologies for geometric error in surface grinding process. International Journal of Machine Tools and Manufacture 45: 327–34.

Laufer, D., Nielsen, O., Wilting, P., Koch, H.J., and Märländer, B. 2016. Yield and nitrogen use efficiency of fodder and sugar beet (Beta vulgaris L.) in contrasting environments of Northwestern Europe. European Journal of Agronomy. 73: 124-132.

Mansouri, H., Bannayan, M., Rezvani Moghaddam, P., and Lakzian, A., 2014. Management of nitrogen fertilizer, irrigation and plant density in onion production using response surface methodology as optimization approach. African Journal of Agricultural Research 9(7): 676-687.

Mansouri, H., Bannayan, M., Rezvani Moghaddam, P., and Lakzian, A., 2015. Management of nitrogen, irrigation and planting density in persian shallot (Allium hirtifolium) by using central composite optimizing method. Agricultural Science and Sustainable Production 24(4): 41-60.

Masri, M.I., Ramadan, B.S.B., El-Shafai, A.M.A., and El-Kady, M.S., 2015. Effect of water stress and fertilization on yield and quality of sugar beet under drip and sprinkler irrigation systems in sandy soil. International Journal of Agriculture Sciences 5(3): 414-425.

Mirzaei, M.R., and Ghadami, A., 2005. Evaluation of quantity and quality of sugar beet under furrow and tape irrigation systems. Final Report of Sugar Beet Seed Institute. Karaj, Iran. (In Persian with English Summary)

Mohammadian, R., 2016. Determination of the best plant population and nitrogen amount of sugar beet under tape drip irrigation system. Final Report of Sugar Beet Seed Institute. Karaj, Iran. (In Persian with English Summary)

Mohammadian, R., Taleghani, D., and Sadeghzadeh, S., 2010. Effect of different irrigation managements on quantity and quality of sugar beet. Sugar Beet 26(2): 139-156.

Montgomery, D.C., 2001. Design and Analysis of Experiments, fifth ed., John Wiley & Sons, New York. 734 p.

Nassiri, M., Koocheki, A., Kamali, G.A., and Shahandeh, H., 2006. Potential impact of climate change on rainfed wheat production in Iran. Archives of Agronomy and Soil Science 52: 113-124.

Noshad, H., Abdollahian-Noghabi, M., and Babaei, B., 2012. Effect of Nitrogen and Phosphorous Application on the Efficiency of Nitrogen Uptake and Consumption in Sugar Beet (Beta vulgaris L.). Iranian Journal of Crop Sciences 43(3): 529-539. (In Persian with English Summary)

Obeng, D.P., Morrell, S., and Napier, T.J.N., 2005. Application of central composite rotatable design to modeling the effect of some operating variables on the performance of the three-product cyclone. International Journal of Mineral Processing 769: 181–92.

Topak, R., Süheri, S., and Acar, B., 2011. Effect of different drip irrigation regimes on sugar beet (Beta vulgaris L.) yield, quality and water use efficiency in Middle Anatolian, Turkey. Irrigation Science 29(1): 79-89.

Wenxue, L., Long, L., Jianhao, S., Tianwen, G., Fusuo, Z., Xingguo, B., Peng A., and Tang, C., 2005. Effects of intercropping and nitrogen application on nitrate present in the profile of an Orthic Anthrosol in Northwest China. Agriculture, Ecosystems and Environment 105: 483–491.

Zulkali, M.M.D., Ahmad, A.L., and Norulakmal, N.H., 2006. Oryza sativa L husk as heavy metal adsorbent: optimization with lead as model solution. Bioresource Technology 97: 21-25.