Evaluation of superabsorbent efficiency in response to dehydration frequencies, salinity and temperature and its effect on yield and quality of cotton under deficit irrigation

Document Type : Scientific - Research

Authors

• Hamid-Reza Fallahi ¹
• Mahsa Aghhavani Shajari ²
• reza tahepour kalantari ¹
• mohammad ghasem soltanzadeh ¹

¹ birjand university

² Department of Agrotechnology, Faculty of Agriculture, Ferdowsi University of Mashhad, Mashhad, Iran

10.22067/jag.v7i4.46446

Abstract

Introduction
Reduced availability of water resources in many arid countries including Iran, particularly in response to the indiscriminate harvesting of water reservoirs and climate change, has created concerns. Therefore, the sustainable use of water resources especially in agriculture is a necessity for these countries. Strategies such as deficit irrigation and superabsorbent application are two important ways for improving water use efficiency in agricultural lands. In deficit irrigation the crop must be irrigated less than its required water. Therefore, some reduction may occur in crop yield, but the savings in water will improve the water use efficiency (Akbari Nodehi, 2011). Superabsorbent polymers also increase the nutrients and water holding capacity of soil for a long time and thereby reduce crop water requirement. However, the effectiveness of these materials could be affected by dehydration frequencies, temperature and irrigation water quality (Karimi et al., 2009). Due to the limitation of water resources in many parts of Iran, the aim of this study was to investigate the possibility of cotton production under deficit irrigation along with application of different rates of superabsorbent. In addition, simulation of superabsorbent efficiency at different levels of salinity, temperature and dehydration frequencies (swelling and de-swelling) were the other objectives in this study.

Materials and methods
1. Laboratory experiments
In these experiments the effects of temperature (4, 10, 20, 30 and 40 °C), salinity (0, 0.25, 0.5, 0.75 and 1% NaCl solutions at two temperatures of 10 and 25°C) and frequency of partial dehydration (from 1 to 5 stages watering and 70% dewatering) were simulated on water absorption capacity of superabsorbent polymer at laboratory of environmental stresses, Sarayan Faculty of Agriculture, Birjand University.

2- Field experiment
This experiment was designed at Research Station of Sarayan Faculty of Agriculture, Birjand University, Iran, during 2014. The experiment was carried out as factorial arrangement based on randomized complete block design with three replications. Study factors were consisted of different levels of superabsorbent (0, 30, 60 and 90 kg.ha-1) and deficit irrigation [irrigation intervals of 12 (control), 15 and 18 days equal to ~120, 155 and 190 mm evaporation from pan, respectively]. Seeds of cotton (Khordad cultivar) were sown in 20 June, with 60×25 cm distances in 3×4 m plots. The harvesting of cotton was performed at three times on 27 Oct, 10 Nov and 17 Nov. At the end of experimental period the yield and quality indices of produced fibers including fiber length, uniformity index, strength, elasticity, fineness (micronaire), brightness, yellowing, ripening ratio and short fibers percentages were measured. Finally, statistical analysis was employed by using the Duncan’s multiple range test at the 5% level of probability.

Results and discussion
Results of laboratory experiments showed that salinity had considerable negative effects on water absorption capacity of superabsorbent in both 10 and 25°C temperatures. The amount of water absorbed by superabsorbent reduced by 73% and 85% by increasing salinity from 0 to 0.25% and to 1%, respectively. In addition, the effect of temperature changes was significant on the water absorption capacity of superabsorbent. The highest value of water absorbed by the superabsorbent was obtained at 20 °C treatment. The amounts of water absorbed at 20 °C, were 8% and 13% higher than 4 °C and 40 °C, respectively. In similar study it has been concluded that swelling of polyaspartic acid hydrogels decreased when the temperature of the aqueous media increased from 25 °C to 60°C (Zhao et al., 2005). The amounts of water absorption ability of superabsorbent during 1 to 5 watering and dewatering cycles were 266, 311, 334, 340 and 355 g g-1, respectively. Results of field experiment showed that cotton yield was significantly affected by irrigation management and superabsorbent application. Application of 60 kg ha-1 superabsorbent along with irrigation intervals of 15 days was the best combined treatment in terms of fiber production. Moreover, experimental factors had no negative effect on the quality indices of produced fibers.

Conclusion
Results of this experiment showed that superabsorbent application and deficit irrigation are the two potential strategies for cotton production in semi-arid regions, especially if low saline water sources are used.

Acknowledgments
We wish to thank Vice President for Research and Technology, University of Birjand, Iran for the financial support of the project (Approved on November 26, 2014).

Keywords: Boll, Fiber fineness, Ripening ratio, Salinity stress, Uniformity

References
Akbari Nodehi, D. 2011. The effect of different water quantities on yield, water use efficiency and cotton yield function in Mazandaran province. Journal of Agricultural Science and Sustainable Production 21: 103-11. (In Persian with English Summary)
Karimi, A., Noshadi, M., and Ahmadzadeh, M. 2009. Effects of super absorbent polymer (igeta) on crop, soil water and irrigation interval. Journal of Water and Soil Science 12(46): 403-414. (In Persian with English Summary)
Zhao, Y., Su, H., Fang, L., and Tan, T. 2005. Superabsorbent hydrogels from poly (aspartic acid) with salt- temperature- and pH-responsiveness properties. Polymer 46: 5368-5376.

Keywords

• Boll
• Micronaire
• Ripening ratio
• Salinity stress
• Uniformity index

---

References

1- Akbari Nodehi, D. 2011. The effect of different water quantities on yield, water use efficiency and cotton yield function in Mazandaran province. Journal of Agricultural Science and Sustainable Production 21: 103-11. (In Persian with English Summary)

2- Fardad, H., and Zeyghami Gol, R. 2005. Optimization of water use for irrigation of cotton in Gorgan. Iranian Journal of Agriculture Science 36(5): 1197-1206. (In Persian)

3- Fathi, D., Sohrabi Moshkabadi, B., and Kouchakzadeh, M. 2011. Evaluation of the effect of irrigation methods, various levels of water and nitrogen fertilizer on quality of cotton. Journal of Plant Production 18(3): 1-15.

4- Fazeli Rostampour, M., and Mohebbian, S.M. 2012. Studying the effects of irrigation deficit and superabsorbent polymer on remobilization of assimilates in corn (Zea mays L.) Environmental Stresses in Crop Sciences 4(2): 127-138. (In Persian with English Summary)

5- Fereres, E., and Soriano, M.A. 2007. Deficit irrigation for reducing agricultural water use. Journal of Experimental Botany 58(2): 147-159.

6- Jahan, M., Nassiri Mohallati, M., Ranjbar, F., Aryaee, M., and Kamayestani, N. 2015. The effects of super absorbent polymer application into soil and humic acid foliar application on some agrophysiological criteria and quantitative and qualitative yield of sugar beet (Beta vulgaris L.) under Mashhad conditions. Journal of Agroecology 6(4): 753-766. (In Persian with English Summary)

7- Ghorbani Nasrabad, G., and Hezarjaribi, A. 2006. Evaluation of the effect of irrigation frequency and irrigation water quantity on yield and fiber quality properties of two cotton cultivars. Journal of Agricultural Science and Natural Resources 13(2): 1-7. (In Persian with English Summary)

8- Ghorbani Nasrabad, G., and Hezarjaribi, A. 2010. Cotton response to deficit irrigation during different growth stages. Journal of Plant Production 17: 129-141. (In Persian with English Summary)

9- Karimi, A., and Naderi, M. 2007. Yield and water use efficiency of forage corn as influenced by superabsorbent polymer application in soils with different textures. Agricultural Research 7(3): 187-198. (In Persian with English Summary)

10- Karimi, A., Noshadi, M., and Ahmadzadeh, M. 2009. Effects of super absorbent polymer (igeta) on crop, soil water and irrigation interval. Journal of Water and Soil Science 12(46): 403-414. (In Persian with English Summary)

11- Karimi Kakhaki, M., and Sepehri, A. 2010. Effect of deficit irrigation on water use efficiency and drought tolerance of new sunflower cultivars at reproductive stage. Journal of Water and Soil Science 13: 163-176. (In Persian with English Summary)

12- Karimi, M., Esfahani, M., Bigluei, M.H., Rabiee, B., and Kafi Ghasemi, A. 2010. Effect of deficit irrigation treatments on morphological traits and growth indices of corn forage in the Rasht climate. Crop Production 2(2): 91-110. (In Persian with English Summary)

13- Khajeh Pour, M.R. 2005. Industrial Crops. Jihad Daneshgahi Publication, Isfahan. (In Persian)

14- Omidian, H., Hashemi, S.A., Sammes, P.G., and Meldrum, I. 1999. Modified acrylic-based superabsorbent polymers (dependence on particle size and salinity). Polymer 40: 1753-1761.

15- Rahbar, E., and Banedjschafie, S. 2009. Salinity effects on water uptake ability of superabsorbent polymer and manure. Iranian Journal of Range and Desert Research 16(2): 209-223. (In Persian with English Summary)

16- Ramezani Etedali, H., Nazari, B., Tavakoli, A., and Parsinejad, M. 2009. Evaluation of CROPWAT model in deficit irrigation management of wheat and barley in Karaj. Journal of Water and Soil 23(1): 119-129. (In Persian with English Summary)

17- Razavi, S.S., and Davary, K. 2014. The role of virtual water in water resource management. Journal of Water and Sustainable Development 1(1): 9-18. (In Persian with English Summary)

18- Rousta, M.J., Soltani, M., Besharat, N., Soltani, V., Salehi, M., and Rangbar, G.H. 2013. The effect of different levels of superabsorbent polymer and water salinity on soil moisture retention. Iranian Water Research Journal 12: 241-244. (In Persian with English Summary)

19- Seyed Dorraji, S., Golchin, A., and Ahmadi, S. 2010. The effects of different levels of a superabsorbent polymer and soil salinity on water holding capacity with three textures of sandy, loamy and clay. Journal of Water and Soil 24(2): 306-316. (In Persian with English Summary)

20- Shayannejad, M. 2010. Effect of deficit irrigation on quantitative properties of winter wheat and determination of its optimum applied water in Shahrekord. Irrigation and Water Engineering 1(2): 24-35. (In Persian with English Summary)

21- Taherkhani, S., Habibi, D., Khodarahmi, M., and Rezaei, M. 2013. Evaluation of application iron, zinc and selenium on yield and yield components and its content in durum wheat: role of super absorbent polymers. Journal of Agronomy and Plant Breeding 9(3): 67-80. (In Persian with English Summary)

22- Tohidi Moghaddam, H., and Mazaheri, A.H. 2012. Effect of manuring fertilizer and super absorbent polymers on qualitative and quantitative characteristics of soybean under water deficit stress conditions. Journal of Crop Production Research 3(4): 375-399. (In Persian with English Summary)

23- Ziaeidoustan, H., Azarpour, E., and Safiyar, S. 2013. Study the effects of different levels of irrigation interval, nitrogen and superabsorbent on yield and yield component of peanut. International Journal of Agriculture and Crop Sciences 5(18): 2071-2078.

24- Zhao, Y., Su, H., Fang, L., and Tan, T. 2005. Superabsorbent hydrogels from poly (aspartic acid) with salt- temperature and pH responsiveness properties. Polymer 46: 5368-5376.